Walking into a Reading, MA bathroom this summer and seeing the picket tile laid out along that tub wall — you already know the sliding glass is going to look clean when it’s done. The crew covered four towns in one stretch this season, putting in everything from bypass tub doors to neo-angle shower doors and corner enclosures with brass hardware. Five jobs, five different setups — here’s what we saw.
4 min read
Sliding Bypass Tub Door on Picket Tile — Reading, MA
The homeowner tiled it themselves — elongated hexagon pattern, floor to ceiling on the tub surround. We set the bypass track along the top with IDEAL Crystal Clear Glass panels and chrome hardware. On tub enclosures, the sweep seal at the bottom only sits right if the deck is level; this one was flat, and the door wiped clean on the first test.
Frameless Pivot Door with Knee Wall — Subway Tile in Windham, NH
Knee wall on the left, full-height glass return on the right, door in the middle — a layout we handle often in smaller bathrooms. White subway tile throughout, gray hexagon mosaic on the floor, and oil-rubbed bronze hinges and pull bar at the homeowner’s request. The door swing cleared the vanity by about two inches on the open side — tight, but it works, and we checked it a dozen times before we left.
Narrow Frameless Door on Blue Zellige Tile — Marblehead, MA
Older Marblehead home — not a lot of floor space to work with. Blue zellige tile inside the shower, floral wallpaper right outside the glass, toilet about a foot from the door. The floor had a slight pitch toward the drain that we had to account for at the hinge to keep the pivot plumb. Once it was set, the door swung clean and the caulk line sat flush against the tile.
Neo-Angle Frameless Enclosure on Gray Stone Tile — Newton, MA
Biggest job of the batch — full neo-angle enclosure, two showerheads, three built-in niches, herringbone mosaic on the floor, IDEAL Crystal Clear Glass on all panels, brushed nickel hardware throughout. Getting the angles right on a neo-angle setup takes more time than a standard inline; every joint has to land clean or the caulk line opens up. This one came out tight. Worth mentioning: if you’re building something like this, ask the Design Team about adding a back-to-back towel bar at the same visit — saves a second trip out.
Black Marble and Brass Hardware — Corner Frameless Enclosure, North Shore
This one stopped us when we walked in. Full black marble tile on the walls and floor, black hexagon mosaic on the shower pan, brass rain head overhead. IDEAL Crystal Clear Glass was the right call here — any tint or coating would have killed the effect the homeowner was going for. Caulk lines on black stone show every gap immediately, so we slowed down on the perimeter seal and made sure it was flat.
Frequently Asked Questions
How do I keep frameless shower glass clean without streaks?
Squeegee after every shower — that’s what we tell every homeowner. Water spots form before you reach for any cleaner, and pulling the water off the glass each time out prevents most of it. If you do need to clean it, diluted white vinegar on a microfiber cloth works better than most commercial sprays and doesn’t leave a film.
How do I know when my shower door sweep seal needs to be replaced?
When water starts escaping under the door onto the floor, that’s your sign. The sweep seal is doing its job as long as water stays inside the enclosure. Most sweeps hold up for a few years with regular use; if you’re looking for a frameless shower door company near me on the North Shore, we can swap one out in a short service visit — it’s not a full reinstall.
What does a frameless shower door cost near Marblehead or Beverly, MA?
Most installs on the North Shore run $800 to $2,500, depending on size, configuration, and hardware finish. A standard pivot door sits toward the lower end; a neo-angle or corner enclosure with custom hardware lands higher. We do free in-home measurements in Danvers, Beverly, Salem, and Marblehead — that’s where you get a real number based on your actual bathroom, not a guess over the phone.
From Tub Sliders to Full Enclosures — We Cover the North Shore
We run jobs regularly in Danvers, Beverly, Salem, Marblehead, Swampscott, Lynn, Peabody, and Middleton. Wherever you are on the North Shore, it’s a short drive for our crew, and we work around your schedule. If a bathroom remodel is on your list this summer, reach out here to get started.
You can also call us directly at (978) 777-9900 — our team picks up and we’ll get you on the calendar. Ready for a free in-home measurement? Schedule one with the Design Team and we’ll come take a look at your space.
