95" 'L' Angle Jamb Seal — Black
A slim polycarbonate L-shaped jamb for frameless shower doors. Works on the hinge side or the strike side, on 1/4" to 1/2" glass.
Temporarily out of stock at our supplier. You can still order; it ships when restocked.
About this jamb seal
The CRL 95" 'L' Angle Jamb Seal is a jamb seal for glass showers that fits 1/4" to 1/2" glass. Made by C.R. Laurence (CRL) in 2 finishes, including black, clear.
This 'L' angle jamb is a replacement seal for frameless swinging shower doors. It works as either the hinge jamb or the strike jamb, and it is a favorite for 135 degree neo-angle showers when you want a clean look. It is bonded to the wall or to a fixed glass panel with clear very high-bond tape (tape is not pre-applied). Each piece is 95" long and made of polycarbonate, in clear or black. It fits 1/4" to 1/2" tempered glass, with a suggested gap of 3/16" between the door and the jamb.
- Fits 1/4" to 1/2" (6 to 12 mm) tempered glass
- 95" (2413 mm) long polycarbonate
- Use as the hinge jamb or the strike jamb
- Also used on 135 degree neo-angle showers
- Bonds to the wall or a fixed panel with clear high-bond tape
Specs
| Finishes | 2 |
|---|---|
| Glazing Thickness | 1/4 in. To 1/2 in. (6 mm To 12 mm) |
| Length | 95 in. (2413 mm) |
| Material | Polycarbonate |
| Minimum Order Quantity | 5 |
| Pre-Applied Tape | No |
Common questions
What glass thickness does the CRL 95" 'L' Angle Jamb Seal fit?
1/4" to 1/2" thick tempered glass. Measure your glass at a bare edge before you order; our measuring guide shows how.
What finishes does it come in?
Black, Clear. Match the finish of the hinges and other hardware on your shower.
Can I return it?
No. All sales are final, so please check your glass thickness, hole spacing and finish before you order.
More like this
Designer Robe Hook
1-11/16" Wide Sliding Shower Door Bottom Guide (2-Pack)
Through-the-Glass Tissue Paper Roll Holder
95" Replacement L-Shaped Vinyl Seal
Beveled Frameless Shower Door Stop
Match your holes, glass and finish.
Measure center to center between your existing holes and check your glass thickness. A new handle has to match both.
How to measure your glass →