Glass Shower Door Won't Stay Closed? Use Magnetic Seals
Frameless doors have no latch, so a door that drifts open leaks. Magnetic seals hold the door against the panel and seal the gap at the same time.
Door won't stay closed (glass door closing against a glass panel)
Answer: Buy a pair of magnetic seals: one strip on the door edge and one on the panel edge, so the magnets pull the door shut and hold it. For a door that swings one way in a straight line, pair one 45° left-hand with one 45° right-hand.
| Your glass | Buy this exact part |
|---|---|
| 1/4" (6 mm) glass | CRL PMA8 $33.58 Magnetic Seal, 45° Left-Hand, for 1/4"–5/16" Glass CRL PMB8 $33.58 Magnetic Seal, 45° Right-Hand, for 1/4"–5/16" Glass |
| 5/16" (8 mm) glass | CRL PMA8 $33.58 Magnetic Seal, 45° Left-Hand, for 1/4"–5/16" Glass CRL PMB8 $33.58 Magnetic Seal, 45° Right-Hand, for 1/4"–5/16" Glass |
| 3/8" (10 mm) glass, the most common | CRL PMA10 $50.38 Magnetic Seal, 45° Left-Hand, for 3/8"–1/2" Glass CRL PMB10 $50.38 Magnetic Seal, 45° Right-Hand, for 3/8"–1/2" Glass |
| 1/2" (12 mm) glass | CRL PMA10 $50.38 Magnetic Seal, 45° Left-Hand, for 3/8"–1/2" Glass CRL PMB10 $50.38 Magnetic Seal, 45° Right-Hand, for 3/8"–1/2" Glass |
Other options:
- Door swings both ways: use two 90° profiles (3/8"–1/2" / 1/4"–5/16"): CRL PMC10 $50.38, CRL PMC8 $33.58
Magnetic seals are made for glass to glass. A door that closes against a wall takes an 'H' wipe or a tape-on seal instead (see the latch-side row).
Which magnetic seal is which?
| Profile | 3/8"–1/2" glass | 1/4"–5/16" glass | Use |
|---|---|---|---|
| 45° left-hand | CRL PMA10 $50.38 | CRL PMA8 $33.58 | Pair with a 45° right-hand: door swings one way, straight line |
| 45° right-hand | CRL PMB10 $50.38 | CRL PMB8 $33.58 | Pair with a 45° left-hand |
| 90° | CRL PMC10 $50.38 | CRL PMC8 $33.58 | Two of them: door swings both ways |
Each product page has a drawing of the profile. Not sure? The Seal Finder narrows it down.
Free shipping to the lower 48 states and DC. On small orders, CRL, the factory that makes these parts, adds its own packing or small-order fee, passed on at cost (see exceptions). All sales are final, so measure your glass first.
How to install magnetic seals
- Check the hinges first. Open the door halfway and let go. If it swings open on its own, a hinge may be out of adjustment or the door is not level. Magnetic seals hold a door that is close to shut.
- Measure the glass thickness. Lay a tape measure across a bare edge. The magnetic seals come in two ranges: 1/4"–5/16" and 3/8"–1/2".
- Pick the pair. Door swings one way in a straight line (180°): one 45° left-hand + one 45° right-hand. Door swings both ways: two 90° profiles.
- Remove the old seals. Pull the old seals off the door edge and the panel edge, and clean both edges with rubbing alcohol.
- Cut both strips to height. Measure the door edge and the panel edge and cut each strip to length with a fine-tooth hacksaw.
- Pressure fit both strips. Press one strip onto the door edge and the other onto the panel edge, from top to bottom, so the two meet when the door closes.
- Test. Close the door gently: the magnets should pull it the last bit and hold it shut. Run the shower and check for drips.
Before you buy: check the hinges
If the door swings open by itself, a hinge may be out of adjustment, or the door is not level. Magnetic seals hold a door that is close to shut; they will not fight a door that wants to swing wide open.
Door closes against a wall?
Magnetic seals are made for glass to glass. For a door that closes against a wall, use an 'H' wipe like CRL P375HW (3/8") on the door edge or a tape-on seal on the wall: see latch side against a wall.
Use our Seal Finder
Pick your door, point to where it leaks and we'll show only the seals that fit your glass. Takes about 30 seconds.
Products in this guide

Magnetic Seal, 45° Left-Hand, for 3/8"–1/2" Glass

Magnetic Seal, 45° Right-Hand, for 3/8"–1/2" Glass

Magnetic Seal, 90°, for 3/8"–1/2" Glass

Magnetic Seal, 45° Left-Hand, for 1/4"–5/16" Glass

Magnetic Seal, 45° Right-Hand, for 1/4"–5/16" Glass

Magnetic Seal, 90°, for 1/4"–5/16" Glass
Common questions
What magnetic seal do I need for a 3/8" frameless shower door?
For a door that swings one way and closes in a straight line against a glass panel: one CRL PMA10 ($50.38) 45° left-hand and one CRL PMB10 ($50.38) 45° right-hand. For a door that swings both ways: two CRL PMC10 ($50.38) 90° profiles. These fit 3/8"–1/2" glass.
Do I need two magnetic seals?
Yes. One strip goes on the door edge and one on the panel edge so the magnets meet. Each strip is sold separately.
Do magnetic shower door seals work on frameless doors?
Yes. They are made for frameless doors that close against a glass panel.
Where do magnetic seals go?
On the door edge and on the panel edge it closes against, so the magnets pull the two together.
Will magnetic seals work against a wall?
They are made for glass to glass. For a door that closes against a wall, use an 'H' wipe or a tape-on seal.
Is shipping free?
Shipping is free to the lower 48 states and DC. On small orders, CRL, the factory that makes these parts, adds its own packing or small-order fee, passed on at cost. All sales are final, so measure your glass first.