Free shipping on every ordersee exceptionsNot sure which seal? Try our Seal Finder →Hinge? Hinge Finder →
CRL PMB8 Magnetic Seal, 45° Right-Hand, for 1/4"–5/16" Glass profile and installed drawing
CRL · Part PMB8In stock

Magnetic Seal, 45° Right-Hand, for 1/4"–5/16" Glass

Magnetic strip for a positive, snug close between glass door and glass panel.

$33.58
+ Free shipping
1/4" / 5/16"Glass thickness
95"Cut to fit
Pressure fitNo tape needed
Ships free to your doorFree on every order to the lower 48 states and DC. Usually ships in 3–7 business days.
Cut it to lengthCRL PTS89 Plastic Trim Snips for Cutting SealsClean, straight or angled cuts on vinyl and plastic seals. $88.49
Free shippingOn every order
All sales finalCheck your glass thickness.
Not sure it fits?Try the Seal Finder
OverviewSpecsFAQGuides

About this seal

The CRL PMB8 is a 95-inch magnetic seal, 45° right-hand, for 1/4"–5/16" glass for 1/4-inch and 5/16-inch glass. Made by C.R. Laurence (CRL); available in clear.

Co-extruded plastic with a soft magnetic receiver that pulls the door closed and holds it. Pressure fits onto the glass edge. Mix and match profiles for your layout. How to pair them: for a door that swings one way in a straight line (180°), use one 45° left-hand + one 45° right-hand. For a door that swings both ways, use two 90° profiles. Fits 1/4"–5/16" glass. 95" length, cut to fit.

  • Magnetic, positive close
  • Fits 1/4"–5/16" glass
  • Pair profiles to suit your door
  • 95" length, cut to fit

Fit & specs

Glass thickness1/4", 5/16"
Installs byPressure fits onto the glass
Used forDoor to fixed glass panel (straight line)
135° neo-angle
Latch (strike) side
Length95 in. (2413 mm)
MaterialPolycarbonate
Pre-Applied TapeNo

Common questions

What glass thickness does the CRL PMB8 fit?

The CRL PMB8 fits 1/4" and 5/16" glass. Measure your glass at the edge before ordering; a seal made for a different thickness will not stay on.

How do I install the CRL PMB8?

It pressure fits onto the edge of the glass; no glue or tape needed. Clean and dry the edge first.

How do I cut the CRL PMB8 to length?

Measure the glass edge where the seal goes, then cut the seal to that length with plastic trim snips like the CRL PTS89 or a fine-tooth hacksaw. The snips give a clean, straight or angled cut in one squeeze.

How long is the PMB8?

It comes in a 95" length that you cut to fit your door.

Can I return the PMB8?

No. All sales are final: due to the nature of shipping these long seals, items cannot be returned. Measure your glass thickness and check the suggested gap before you order; our measuring guide shows how.

Finish the job

You may also need

Related guide

Glass Shower Door Won't Stay Closed? Use Magnetic Seals

Frameless doors have no latch, so a door that drifts open leaks.

Read the guide →