Free shipping on every ordersee exceptionsNot sure which seal? Try our Seal Finder →Hinge? Hinge Finder →
CRL P375HW Multi-Purpose 'H' Wipe for 3/8" Glass profile and installed drawing
Most common
CRL · Part P375HWIn stock

Multi-Purpose 'H' Wipe for 3/8" Glass

One of our most versatile seals. We use it all the time.

$15.23
+ Free shipping
3/8"Glass thickness
95"Cut to fit
Pressure fitNo tape needed
Ships free to your doorFree on every order to the lower 48 states and DC. Usually ships in 3–7 business days.
Cut it to lengthCRL PTS89 Plastic Trim Snips for Cutting SealsClean, straight or angled cuts on vinyl and plastic seals. $88.49
Free shippingOn every order
All sales finalCheck your glass thickness.
Not sure it fits?Try the Seal Finder
OverviewSpecsFAQGuides

About this seal

The CRL P375HW is a 95-inch multi-purpose 'h' wipe for 3/8-inch glass. Made by C.R. Laurence (CRL); available in clear.

Two rigid legs grip the glass and two soft legs do the sealing. Our installers use this one constantly: to seal a door against a wall, on the hinge or pivot side against the panel that supports the door, between a door and a fixed panel, and even as a bottom sweep. Trim one or both soft legs to fit your setup. Pressure fits onto the edge of the glass. For 3/8" glass. 95" length, cut to fit.

  • Seals a door against a wall
  • Hinge or pivot side, against the panel that supports the door
  • Door to fixed panel in a straight line (180°)
  • Works as a bottom sweep too
  • 95" length, cut to fit

Fit & specs

Glass thickness3/8"
Installs byPressure fits onto the glass
Used forDoor against a wall
Hinge or pivot side
Door to fixed glass panel (straight line)
Bottom of the door
Hardness70-75 durometer
Length95 in. (2413 mm)
MaterialPolycarbonate
Pre-Applied TapeNo

Common questions

What glass thickness does the CRL P375HW fit?

The CRL P375HW fits 3/8" glass. Measure your glass at the edge before ordering; a seal made for a different thickness will not stay on.

How do I install the CRL P375HW?

It pressure fits onto the edge of the glass; no glue or tape needed. Clean and dry the edge first.

How do I cut the CRL P375HW to length?

Measure the glass edge where the seal goes, then cut the seal to that length with plastic trim snips like the CRL PTS89 or a fine-tooth hacksaw. The snips give a clean, straight or angled cut in one squeeze.

How long is the P375HW?

It comes in a 95" length that you cut to fit your door.

Can I return the P375HW?

No. All sales are final: due to the nature of shipping these long seals, items cannot be returned. Measure your glass thickness and check the suggested gap before you order; our measuring guide shows how.

Finish the job

You may also need