3" Aluminum Slip-On Finger Pull — Satin Anodized
A low-profile aluminum pull that slips over the edge of a 1/4" glass door. No holes to drill.
Temporarily out of stock at our supplier. You can still order; it ships when restocked.
About this handle
The CRL 3" Aluminum Slip-On Finger Pull is a pull handle for frameless glass shower doors that fits 1/4" glass. Made by C.R. Laurence (CRL) in 2 finishes, including satin anodized, dark bronze anodized.
This extruded aluminum finger pull fits over the edge of a 1/4" thick sliding glass or panel door, giving you a slim place to grip. It is held on with a press fit using Tuff-Pak tape sized for the glass. The pull is 3" long with a 7/16" lip. It is made for 1/4" thick glass only and needs no holes, just a clean glass edge.
- Slips over the glass edge, no drilling needed
- 3" (76 mm) long with a 7/16" (11 mm) lip
- Extruded aluminum
- Press fit with Tuff-Pak tape
- For 1/4" (6 mm) thick glass and panel doors
Specs
| Finishes | 2 |
|---|---|
| Glazing Thickness | 1/4 in. (6 mm) |
| Length | 3 in. (76.2 mm) |
| Lip | 7/16 in. (11.1 mm) |
| Material | Aluminum |
Common questions
What glass thickness does the CRL 3" Aluminum Slip-On Finger Pull fit?
1/4" thick tempered glass. Measure your glass at a bare edge before you order; our measuring guide shows how.
What finishes does it come in?
Satin Anodized, Dark Bronze Anodized. Match the finish of the hinges and other hardware on your shower.
Can I return it?
No. All sales are final, so please check your glass thickness, hole spacing and finish before you order.
More like this
8" Back-to-Back Tubular Pull Handle
Traditional Back-to-Back Shower Door Knobs
24" Ladder Style Pull Handle
8" Back-to-Back Square Pull Handle
Round Thru-Glass Finger Pull
Match your holes, glass and finish.
Measure center to center between your existing holes and check your glass thickness. A new handle has to match both.
How to measure your glass →