Free shipping on every ordersee exceptionsNot sure which seal? Try our Seal Finder →Hinge? Hinge Finder →
CRL PCR10 Clear Bulb Seal for 3/8" Glass profile and installed drawing
Most common
CRL · Part PCR10In stock

Clear Bulb Seal for 3/8" Glass

Clip-on bulb seal for doors that swing in, out, or both.

$29.38
+ Free shipping
3/8"Glass thickness
1/4"Gap
95"Cut to fit
Pressure fitNo tape needed
Ships free to your doorFree on every order to the lower 48 states and DC. Usually ships in 3–7 business days.
Cut it to lengthCRL PTS89 Plastic Trim Snips for Cutting SealsClean, straight or angled cuts on vinyl and plastic seals. $88.49
Free shippingOn every order
All sales finalCheck your glass thickness.
Not sure it fits?Try the Seal Finder
OverviewSpecsFAQGuides

About this seal

The CRL PCR10 is a 95-inch clear bulb seal for 3/8-inch glass, with a suggested 1/4" gap. Made by C.R. Laurence (CRL); available in clear.

A clear "U" pressure fits onto the edge of the door or panel, and a soft bulb seals the gap. Because the bulb gives both ways, the door can swing in or out of the shower. For 3/8" glass. 95" length, cut to fit. It also seals a 3/8" sliding door where it closes against the wall.

  • Door can swing in or out
  • Clips on, no tape needed
  • Suggested gap: 1/4"
  • 95" length, cut to fit

Fit & specs

Glass thickness3/8"
Gap1/4"
Door swingInswing or outswing
Installs byPressure fits onto the glass
Used forHinge or pivot side
Latch (strike) side
Door against a wall
Door to fixed glass panel (straight line)
Sliding doors
Length95 in. (2413 mm)
MaterialPolycarbonate

Common questions

What glass thickness does the CRL PCR10 fit?

The CRL PCR10 fits 3/8" glass. Measure your glass at the edge before ordering; a seal made for a different thickness will not stay on.

What gap does the PCR10 seal?

The suggested gap is 1/4". Measure with the door closed.

How do I install the CRL PCR10?

It pressure fits onto the edge of the glass; no glue or tape needed. Clean and dry the edge first.

How do I cut the CRL PCR10 to length?

Measure the glass edge where the seal goes, then cut the seal to that length with plastic trim snips like the CRL PTS89 or a fine-tooth hacksaw. The snips give a clean, straight or angled cut in one squeeze.

How long is the PCR10?

It comes in a 95" length that you cut to fit your door.

Can I return the PCR10?

No. All sales are final: due to the nature of shipping these long seals, items cannot be returned. Measure your glass thickness and check the suggested gap before you order; our measuring guide shows how.

Finish the job

You may also need

Related guide

H-Jamb vs. Bulb Seal: Which Shower Door Seal Do You Need?

Both close the gap along the vertical edge of the door.

Read the guide →