Clear Bulb Seal for 1/2" Glass
Clip-on bulb seal for doors that swing in, out, or both.
Temporarily out of stock at our supplier. You can still order; it ships when restocked.
About this seal
The CRL PCR12 is a 95-inch clear bulb seal for 1/2-inch glass, with a suggested 1/4" gap. Made by C.R. Laurence (CRL); available in clear.
A clear "U" pressure fits onto the edge of the door or panel, and a soft bulb seals the gap. Because the bulb gives both ways, the door can swing in or out of the shower. For 1/2" glass. 95" length, cut to fit.
- Door can swing in or out
- Clips on, no tape needed
- Suggested gap: 1/4"
- 95" length, cut to fit
Fit & specs
| Glass thickness | 1/2" |
|---|---|
| Gap | 1/4" |
| Door swing | Inswing or outswing |
| Installs by | Pressure fits onto the glass |
| Used for | Hinge or pivot side Latch (strike) side Door against a wall Door to fixed glass panel (straight line) |
| Length | 95 in. (2413 mm) |
| Material | Polycarbonate |
Common questions
What glass thickness does the CRL PCR12 fit?
The CRL PCR12 fits 1/2" glass. Measure your glass at the edge before ordering; a seal made for a different thickness will not stay on.
What gap does the PCR12 seal?
The suggested gap is 1/4". Measure with the door closed.
How do I install the CRL PCR12?
It pressure fits onto the edge of the glass; no glue or tape needed. Clean and dry the edge first.
How do I cut the CRL PCR12 to length?
Measure the glass edge where the seal goes, then cut the seal to that length with plastic trim snips like the CRL PTS89 or a fine-tooth hacksaw. The snips give a clean, straight or angled cut in one squeeze.
How long is the PCR12?
It comes in a 95" length that you cut to fit your door.
Can I return the PCR12?
No. All sales are final: due to the nature of shipping these long seals, items cannot be returned. Measure your glass thickness and check the suggested gap before you order; our measuring guide shows how.
