Free shipping on every ordersee exceptionsNot sure which seal? Try our Seal Finder →Hinge? Hinge Finder →
CRL P516HJ Clear 'H' Jamb, 180°, for 5/16" Glass profile and installed drawing
CRL · Part P516HJIn stock

Clear 'H' Jamb, 180°, for 5/16" Glass

Our most popular straight-line seal. All-rigid and nearly invisible.

$18.38
+ Free shipping
5/16"Glass thickness
3/16"Gap
95"Cut to fit
Pressure fitNo tape needed
Ships free to your doorFree on every order to the lower 48 states and DC. Usually ships in 3–7 business days.
Cut it to lengthCRL PTS89 Plastic Trim Snips for Cutting SealsClean, straight or angled cuts on vinyl and plastic seals. $88.49
Free shippingOn every order
All sales finalCheck your glass thickness.
Not sure it fits?Try the Seal Finder
OverviewSpecsFAQ

About this seal

The CRL P516HJ is a 95-inch clear 'h' jamb, 180°, for 5/16-inch glass, with a suggested 3/16" gap. Made by C.R. Laurence (CRL); available in clear.

Pressure fits onto the edge of the fixed panel with the lip on the latch side, or onto the door with the lip on the hinge side. The lip overlaps the gap so water can't get through where the door closes in a straight line. Entirely rigid polycarbonate for a clean, clear look. For 5/16" glass. 95" length, cut to fit.

  • Most popular straight-line (180°) seal
  • Clear, low-profile look
  • Suggested gap: 3/16"
  • 95" length, cut to fit

Fit & specs

Glass thickness5/16"
Gap3/16"
Installs byPressure fits onto the glass
Used forDoor to fixed glass panel (straight line)
Latch (strike) side
Hinge or pivot side
Length95 in. (2413 mm)
MaterialPolycarbonate
Pre-Applied TapeNo

Common questions

What glass thickness does the CRL P516HJ fit?

The CRL P516HJ fits 5/16" glass. Measure your glass at the edge before ordering; a seal made for a different thickness will not stay on.

What gap does the P516HJ seal?

The suggested gap is 3/16". Measure with the door closed.

How do I install the CRL P516HJ?

It pressure fits onto the edge of the glass; no glue or tape needed. Clean and dry the edge first.

How do I cut the CRL P516HJ to length?

Measure the glass edge where the seal goes, then cut the seal to that length with plastic trim snips like the CRL PTS89 or a fine-tooth hacksaw. The snips give a clean, straight or angled cut in one squeeze.

How long is the P516HJ?

It comes in a 95" length that you cut to fit your door.

Can I return the P516HJ?

No. All sales are final: due to the nature of shipping these long seals, items cannot be returned. Measure your glass thickness and check the suggested gap before you order; our measuring guide shows how.

Finish the job

You may also need