Clear Vinyl 'T' Edge Wipe, up to 7/16" Gap
Tape-on 'T' wipe for larger gaps. Trims down for smaller ones.
Temporarily out of stock at our supplier. You can still order; it ships when restocked.
About this seal
The CRL SDTW is a 95-inch clear vinyl 't' edge wipe, up to 7/16" gap, closing gaps up to 7/16". Made by C.R. Laurence (CRL); available in clear.
The rigid base mounts to the glass edge or wall and the soft leg closes gaps up to 7/16". Trim it for smaller gaps. Works on inswing or outswing doors. Mount with clear double-sided VHB tape (not included). 95" length, cut to fit. Sold in a minimum of 5.
- Gaps up to 7/16"
- Trim for smaller gaps
- Inswing or outswing
- Tape not included
- Minimum order: 5
Fit & specs
| Glass thickness | Any |
|---|---|
| Gap | up to 7/16" |
| Door swing | Inswing or outswing |
| Installs by | Clear VHB tape (not included) |
| Used for | Hinge or pivot side Latch (strike) side Door against a wall |
| Length | 95 in. (2413 mm) |
| Material | Polycarbonate |
| Pre-Applied Tape | No |
Common questions
Does the SDTW depend on glass thickness?
No. The SDTW mounts to the glass edge or wall, so choose it by the gap it closes (up to 7/16") rather than by glass thickness.
What gap does the SDTW seal?
It closes gaps up to 7/16". Measure with the door closed.
How do I install the CRL SDTW?
Mount it with clear double-sided VHB tape (sold separately) on a clean, dry glass edge or wall.
How do I cut the CRL SDTW to length?
Measure the glass edge where the seal goes, then cut the seal to that length with plastic trim snips like the CRL PTS89 or a fine-tooth hacksaw. The snips give a clean, straight or angled cut in one squeeze.
How long is the SDTW?
It comes in a 95" length that you cut to fit your door.
Can I return the SDTW?
No. All sales are final: due to the nature of shipping these long seals, items cannot be returned. Measure your glass thickness and check the suggested gap before you order; our measuring guide shows how.
You may also need
Ships from IDEALIDEAL Bath Kit
Clear Silicone Bulb Seal, 1/16"–3/16" Gap
Clear Silicone Bulb Seal, 1/16"–3/16" Gap (Pre-Taped)
Clear Vinyl Bulb Seal, 3/16" to 3/8" Gap
