90° Strike Seal with Vinyl Insert for 3/8" Glass
Sturdy corner seal for a fixed panel that meets the door at 90°.
The CRL P090SJ is a 95-inch 90° strike seal with vinyl insert for 3/8-inch glass, with a suggested 3/16" gap. Made by C.R. Laurence (CRL); available in clear.
Temporarily out of stock at our supplier. You can still order; it ships when restocked.
- For 90° panel-to-door corners
- Vinyl insert included
- Suggested gap: 3/16"
- 95" length, cut to fit
Related guides
About this seal
A clear polycarbonate 'U' that pressure fits onto the latch-side fixed panel where it meets the door at a right angle. A clear vinyl insert is included for extra protection. For 3/8" glass. 95" length, cut to fit.
Fit & specs
| Glass thickness | 3/8" |
|---|---|
| Gap | 3/16" |
| Installs by | Pressure fits onto the glass |
| Used for | 90° corner Latch (strike) side |
| Glass To Glass Angle | 90 |
| Length | 95 in. (2413 mm) |
| Material | Polycarbonate |
| Pre-Applied Tape | No |
Common questions
What glass thickness does the CRL P090SJ fit?
The CRL P090SJ fits 3/8" glass. Measure your glass at the edge before ordering; a seal made for a different thickness will not stay on.
What gap does the P090SJ seal?
The suggested gap is 3/16". Measure with the door closed.
How do I install the CRL P090SJ?
It pressure fits onto the edge of the glass; no glue or tape needed. Clean and dry the edge first.
How do I cut the CRL P090SJ to length?
Measure the glass edge where the seal goes, then cut the seal to that length with plastic trim snips like the CRL PTS89 or a fine-tooth hacksaw. The snips give a clean, straight or angled cut in one squeeze.
How long is the P090SJ?
It comes in a 95" length that you cut to fit your door.
Can I return the P090SJ?
No. All sales are final: due to the nature of shipping these long seals, items cannot be returned. Measure your glass thickness and check the suggested gap before you order; our measuring guide shows how.
