Bottom Rail with Replaceable Wipe for 1/2" Glass
Rigid bottom rail with a slide-in vinyl wipe. Pressure fits onto the bottom of the door.
The CRL P660BR is a 95-inch bottom rail with replaceable wipe for 1/2-inch glass. Made by C.R. Laurence (CRL); available in clear.
Temporarily out of stock at our supplier. You can still order; it ships when restocked.
- Wipe slides out for easy replacement
- Includes the vinyl "T" wipe
- 95" length, cut to fit
About this seal
A clear polycarbonate rail that pressure fits onto the bottom of the door, with a translucent "T" wipe that slides into its slot. When the wipe wears out, you can replace just the wipe (part SDTW). For 1/2" glass. 95" length, cut to fit.
Fit & specs
| Glass thickness | 1/2" |
|---|---|
| Installs by | Pressure fits onto the glass |
| Used for | Bottom of the door |
| Length | 95 in. (2413 mm) |
| Material | Polycarbonate |
| Pre-Applied Tape | No |
Common questions
What glass thickness does the CRL P660BR fit?
The CRL P660BR fits 1/2" glass. Measure your glass at the edge before ordering; a seal made for a different thickness will not stay on.
How do I install the CRL P660BR?
It pressure fits onto the edge of the glass; no glue or tape needed. Clean and dry the edge first.
How do I cut the CRL P660BR to length?
Measure the width of the door at the bottom, then cut the seal with plastic trim snips like the CRL PTS89 or a fine-tooth hacksaw. Cut it a hair short so the ends don't drag on the wall or panel.
How long is the P660BR?
It comes in a 95" length that you cut to fit your door.
Can I return the P660BR?
No. All sales are final: due to the nature of shipping these long seals, items cannot be returned. Measure your glass thickness and check the suggested gap before you order; our measuring guide shows how.
