Bottom Bulb Wipe with Drip Rail for 3/8" Glass
Soft bulb bottom seal with a drip rail. Pressure fits onto the bottom of the door.
The CRL P910BWS is a 95-inch bottom bulb wipe with drip rail for 3/8-inch glass, with a suggested 1/4" gap. Made by C.R. Laurence (CRL); available in clear.
Temporarily out of stock at our supplier. You can still order; it ships when restocked.
- Soft bulb seals without dragging
- Ideal for rise-and-fall hinges
- Suggested gap under the door: 1/4"
- 95" length, cut to fit
About this seal
A soft rounded bulb seals against the curb, and the 45° drip rail sheds water back into the shower. A great choice for doors on rise-and-fall hinges, which lift slightly as they open. For 3/8" glass. 95" length, cut to fit.
Fit & specs
| Glass thickness | 3/8" |
|---|---|
| Gap | 1/4" |
| Installs by | Pressure fits onto the glass |
| Used for | Bottom of the door |
| Length | 95 in. (2413 mm) |
| Material | Polycarbonate |
| Pre-Applied Tape | No |
Common questions
What glass thickness does the CRL P910BWS fit?
The CRL P910BWS fits 3/8" glass. Measure your glass at the edge before ordering; a seal made for a different thickness will not stay on.
What gap does the P910BWS seal?
The suggested gap is 1/4". Measure with the door closed.
How do I install the CRL P910BWS?
It pressure fits onto the edge of the glass; no glue or tape needed. Clean and dry the edge first.
How do I cut the CRL P910BWS to length?
Measure the width of the door at the bottom, then cut the seal with plastic trim snips like the CRL PTS89 or a fine-tooth hacksaw. Cut it a hair short so the ends don't drag on the wall or panel.
How long is the P910BWS?
It comes in a 95" length that you cut to fit your door.
Can I return the P910BWS?
No. All sales are final: due to the nature of shipping these long seals, items cannot be returned. Measure your glass thickness and check the suggested gap before you order; our measuring guide shows how.
