Bottom Wipe with Drip Rail, Cambridge & Crescent Sliders (3/8")
Bottom sweep sized for Cambridge and Crescent sliding doors with 3/8" glass.
The CRL P995WS is a 40-inch bottom wipe with drip rail, cambridge & crescent sliders (3/8") for 3/8-inch glass. Made by C.R. Laurence (CRL); available in clear.
Temporarily out of stock at our supplier. You can still order; it ships when restocked.
- Made for Cambridge & Crescent sliders
- 45° drip rail
- 40" length, cut to fit
Related guides
About this seal
Pressure fits onto the bottom of a sliding door. Soft wipes seal against the floor or curb and the 45° drip rail sheds water back in. Sized for the Cambridge and Crescent sliding systems. 40" length, cut to fit.
Fit & specs
| Glass thickness | 3/8" |
|---|---|
| Installs by | Pressure fits onto the glass |
| Used for | Bottom of the door Sliding doors |
| Length | 40 in. (1016 mm) |
| Material | Polycarbonate |
| Pre-Applied Tape | No |
Common questions
What glass thickness does the CRL P995WS fit?
The CRL P995WS fits 3/8" glass. Measure your glass at the edge before ordering; a seal made for a different thickness will not stay on.
How do I install the CRL P995WS?
It pressure fits onto the edge of the glass; no glue or tape needed. Clean and dry the edge first.
How do I cut the CRL P995WS to length?
Measure the width of the door at the bottom, then cut the seal with plastic trim snips like the CRL PTS89 or a fine-tooth hacksaw. Cut it a hair short so the ends don't drag on the wall or panel.
How long is the P995WS?
It comes in a 40" length that you cut to fit your door.
Can I return the P995WS?
No. All sales are final: due to the nature of shipping these long seals, items cannot be returned. Measure your glass thickness and check the suggested gap before you order; our measuring guide shows how.
