Free shippingCRL fees on small ordersNot sure which seal? Try our Seal Finder →Hinge? Hinge Finder →
Shower Door Clear Vinyl 'V' Edge Seal, 3/16"–1/4" Gap (Pre-Taped) – CRL SDTST2 profile drawing
CRL · Part SDTST2In stock

Clear Vinyl 'V' Edge Seal, 3/16"–1/4" Gap (Pre-Taped)

Tape-on 'V' seal for doors that swing one way.

$68.25 / 5-pack$13.65 each · sold in packs of 5
+ Free shipping
Sold in packs of 5. Our supplier only ships this seal in quantities of 5 or more, so each pack is 5 full lengths ($13.65 each).
3/16" to 1/4"Gap
95"Cut to fit
Peel & stickTape applied
Ships free to your doorFree to the lower 48 states and DC. Usually ships in 3–7 business days.
Plastic Trim Snips for Cutting Seals, Black – CRL PTS89 product photo
Cut it to lengthCRL PTS89 Plastic Trim Snips for Cutting SealsClean, straight or angled cuts on vinyl and plastic seals. $88.49
Free shippingLower 48 & DC
All sales finalCheck your glass thickness.
Not sure it fits?Try the Seal Finder
OverviewSpecsFAQ

About this seal

The CRL SDTST2 is a 95-inch clear vinyl 'v' edge seal, 3/16"–1/4" gap (pre-taped), closing gaps 3/16" to 1/4". Made by C.R. Laurence (CRL); available in clear.

The rigid leg tapes to the glass edge or wall and the door closes into the soft vinyl leg. Seals gaps from 3/16" to 1/4". For doors that swing in one direction only. Comes with tape already applied. 95" length, cut to fit. Sold in a minimum of 5.

  • Seals gaps 3/16" to 1/4"
  • One-way swing doors
  • Pre-applied tape
  • Minimum order: 5

Fit & specs

Glass thicknessAny
Gap3/16" to 1/4"
Door swingOne direction only
Installs byPeel and stick (tape applied)
Used for135° neo-angle
90° corner
Latch (strike) side
Door against a wall
Length95 in. (2413 mm)
MaterialVinyl
Pre-Applied TapeYes

Common questions

Does the SDTST2 depend on glass thickness?

No. The SDTST2 mounts to the glass edge or wall, so choose it by the gap it closes (3/16" to 1/4") rather than by glass thickness.

What gap does the SDTST2 seal?

It closes gaps from 3/16" to 1/4". Measure with the door closed.

How do I install the CRL SDTST2?

It comes with clear tape already applied: clean the surface, peel the liner and press it in place.

How do I cut the CRL SDTST2 to length?

Measure the glass edge where the seal goes, then cut the seal to that length with plastic trim snips like the CRL PTS89 or a fine-tooth hacksaw. The snips give a clean, straight or angled cut in one squeeze.

How long is the SDTST2?

It comes in a 95" length that you cut to fit your door.

Can I return the SDTST2?

No. All sales are final: due to the nature of shipping these long seals, items cannot be returned. Measure your glass thickness and check the suggested gap before you order; our measuring guide shows how.

Finish the job

You may also need