No-Drill Fixed Panel Glass Clamp for 1/4" Glass — Polished Chrome
Holds a 1/4" fixed glass panel with set screws instead of a hole in the glass.
Temporarily out of stock at our supplier. You can still order; it ships when restocked.
About this clamp
The CRL No-Drill Fixed Panel Glass Clamp for 1/4" Glass is a glass clamp for frameless glass showers that holds a fixed glass panel to the wall, curb or floor; it fits 1/4" glass. Made by C.R. Laurence (CRL) in 2 finishes, including polished chrome, brushed nickel.
This clamp grips the glass with two nylon-tipped set screws, so the panel doesn't need holes or notches. Mounting screws for the wall, ceiling or floor and clear gaskets are included. Use silicone along the glass edges too, and never hang a door off a panel held only by these clamps. Solid brass, for 1/4" (6 mm) tempered glass.
- Fits 1/4" (6 mm) glass
- No holes or notches needed
- Two nylon-tipped set screws
- Not for panels that carry a door
- Solid brass
Specs
| Finishes | 2 |
|---|---|
| Glazing Thickness | 1/4 in. (6 mm) |
| Material | Brass |
| Mounting Type | Wall Mount |
Complete the look in Polished Chrome
Common questions
What glass thickness does the CRL No-Drill Fixed Panel Glass Clamp for 1/4" Glass fit?
1/4" thick tempered glass. Measure your glass at a bare edge before you order; our measuring guide shows how.
How many clamps do I need?
This is one glass clamp. Most fixed panels use two or three clamps. Replace a worn clamp with the same style, size and finish so it lines up with the others.
What finishes does it come in?
Polished Chrome, Brushed Nickel. Match the finish of the hinges and other hardware on your shower.
Can I return it?
No. All sales are final, so please check your glass thickness, clamp style and finish before you order.
More like this
Square Hole-in-Glass Fixed Panel U-Clamp
Beveled Hole-in-Glass Fixed Panel U-Clamp
Square 90° Glass-to-Glass Clamp
90° "Sleeve Over" Glass Clamp
Oversized Fixed Panel U-Clamp
Match your holes, glass and finish.
Measure center to center between your existing holes and check your glass thickness. A new handle has to match both.
How to measure your glass →