'H' Jamb with Soft Fin, 180°, for 3/8" Glass
Straight-line seal with a soft fin that catches and holds the door in line.
The CRL P338HWS is a 95-inch 'h' jamb with soft fin, 180°, for 3/8-inch glass, with a suggested 3/16" gap. Made by C.R. Laurence (CRL); available in clear.
Temporarily out of stock at our supplier. You can still order; it ships when restocked.
- Soft fin holds the door in line
- Clear look
- Suggested gap: 3/16"
- 95" length, cut to fit
About this seal
Pressure fits onto the 3/8" fixed panel with the lip on the latch side, or onto the door with the lip on the hinge side. One soft fin captures the door when it closes, keeping it lined up with the panel. 95" length, cut to fit.
Fit & specs
| Glass thickness | 3/8" |
|---|---|
| Gap | 3/16" |
| Installs by | Pressure fits onto the glass |
| Used for | Door to fixed glass panel (straight line) Latch (strike) side Hinge or pivot side |
| Length | 95 in. (2413 mm) |
| Material | Polycarbonate |
| Pre-Applied Tape | No |
Common questions
What glass thickness does the CRL P338HWS fit?
The CRL P338HWS fits 3/8" glass. Measure your glass at the edge before ordering; a seal made for a different thickness will not stay on.
What gap does the P338HWS seal?
The suggested gap is 3/16". Measure with the door closed.
How do I install the CRL P338HWS?
It pressure fits onto the edge of the glass; no glue or tape needed. Clean and dry the edge first.
How do I cut the CRL P338HWS to length?
Measure the glass edge where the seal goes, then cut the seal to that length with plastic trim snips like the CRL PTS89 or a fine-tooth hacksaw. The snips give a clean, straight or angled cut in one squeeze.
How long is the P338HWS?
It comes in a 95" length that you cut to fit your door.
Can I return the P338HWS?
No. All sales are final: due to the nature of shipping these long seals, items cannot be returned. Measure your glass thickness and check the suggested gap before you order; our measuring guide shows how.
