Clear U-Channel with 1-1/4" Fin for 3/8" Glass
Sliding-door seal with a long 1-1/4" fin, made for the Deluxe Serenity system.
The CRL PCSER78 is a 95-inch clear u-channel with 1-1/4" fin for 3/8-inch glass. Made by C.R. Laurence (CRL); available in clear.
Temporarily out of stock at our supplier. You can still order; it ships when restocked.
- 1-1/4" sealing fin
- Made for Deluxe Serenity sliders
- Also works as a 90° panel seal
- 95" length, cut to fit
Related guides
About this seal
A clear U-channel that pressure fits onto the edge of a sliding door or fixed panel, with a long 1-1/4" fin to close the gap between them. Made for the Deluxe Serenity sliding system and also works as a 90° seal where a fixed panel meets a door. For 3/8" glass. 95" length, cut to fit.
Fit & specs
| Glass thickness | 3/8" |
|---|---|
| Installs by | Pressure fits onto the glass |
| Used for | Sliding doors 90° corner |
| Length | 95 in. (2413 mm) |
| Material | Polycarbonate |
| Pre-Applied Tape | No |
Common questions
What glass thickness does the CRL PCSER78 fit?
The CRL PCSER78 fits 3/8" glass. Measure your glass at the edge before ordering; a seal made for a different thickness will not stay on.
How do I install the CRL PCSER78?
It pressure fits onto the edge of the glass; no glue or tape needed. Clean and dry the edge first.
How do I cut the CRL PCSER78 to length?
Measure the glass edge where the seal goes, then cut the seal to that length with plastic trim snips like the CRL PTS89 or a fine-tooth hacksaw. The snips give a clean, straight or angled cut in one squeeze.
How long is the PCSER78?
It comes in a 95" length that you cut to fit your door.
Can I return the PCSER78?
No. All sales are final: due to the nature of shipping these long seals, items cannot be returned. Measure your glass thickness and check the suggested gap before you order; our measuring guide shows how.
